Repair Guide: Sunbeam Alpine Ignition Coil Failure
The Sunbeam Alpine is a classic English sports car that offers a distinct driving experience. However, like all vehicles, it may face mechanical issues over time and one less common problem encountered is ignition coil failure. This guide offers a step-by-step approach to resolving this issue.
Tools Required
- Screwdriver set
- Socket set
- Wire cutter
- New ignition coil
Step-by-Step Guide
Step 1: Disconnect the Battery
Before starting any work on the ignition system, first disconnect the battery to prevent any accidental electrical discharge.
Step 2: Locate the Ignition Coil
The ignition coil in a Sunbeam Alpine is located near the distributor. It is cylindrical and has a wire leading into the distributor cap.
Step 3: Remove the Old Ignition Coil
Use the correct screwdriver to remove the screws securing the ignition coil bracket. Once loose, you can disconnect the coil wires using the wire cutters. Remember to mark the position of these wires as it will be necessary for the installation of the new coil.
Step 4: Install the New Ignition Coil
Place the new coil in the bracket. Reattach the coil wires in the same position they were in the old coil. Secure the new coil using the bracket and screws.
Step 5: Reconnect the Battery
Finally, reconnect the battery. Start the car to check if the new coil is properly installed and functioning.
Conclusion
Replacing an ignition coil on a Sunbeam Alpine may seem challenging, but with the right tools and this guide, you should be able to complete the task successfully. Always remember to work safely when dealing with the car's electrical system.
```